Dip the tip of the pen in the rubbing alcohol. This process helps the hardened ink to dissolve. If not, then you should probably proceed to the second strategy. Using your match or lighter, slowly heat up the tip of the pen.
Enough heat should melt the dried ink. Repeat this process until the ink freely flows. But be careful because too much heat could also melt the whole pen. When doing this process, constant checking on the temperature may be necessary.
Occasionally touch the tip of the pen by your fingers. Then repeat the process intermittently. After performing the second step, carefully strike the pen on the edge of a table or any hard surface to remove any blockage that stops the roller ball to move freely. Again, do not apply too much force while doing this.
This could totally ruin your pen. Now, try to write on rough paper or cardboard. This will help the stuck ink to dislodge from the rollerball. Your pen should be working at this point. Whatever problems you encountered with your pen, you always need one thing — patience.
That is right, patience. Related Articles. Article Summary. Method 1. All rights reserved. This image may not be used by other entities without the express written consent of wikiHow, Inc. Put the pen in boiling-hot water for 5 minutes to avoid using flames. Set the pen tip-down in the water for about 5 minutes, then test it out on a piece of paper. If your pen has any metal components, dry them thoroughly to prevent corrosion.
Warm the pen with a blow dryer or craft heat gun for gentler heating. For slightly more powerful heating, you can also use a craft heat gun or embossing gun.
Warm the nib of the pen for a few seconds at a time, then try writing with it. They get extremely hot and will probably melt your pen. Hold the tip of the pen to a flame for a few seconds to unclog the ink.
Use a lighter, match, or candle to create a flame, then place just the very tip of your pen in the flame for a few seconds. In many cases, the heat will melt any gummed-up ink near the tip and get the pen working again.
Scribble on some paper right away to get the ink moving and check if your pen works. Method 2. Dab a little spit on the nib to lubricate the ball. This may sound gross, but spit can act as a lubricant or gentle solvent to help unclog the tip of your pen. Then, scribble on a piece of paper to see if you can get the ink flowing. Dip the point of the pen in rubbing alcohol to dissolve clogs. If some of the ink is dried out in the pen, you might be able to get it going by thinning it a little with rubbing alcohol.
Pour some alcohol into a cup or bowl and dip the pen into it, then scribble on a piece of paper to see if you can get it flowing again. Solvents, such as alcohol, are better at thinning oil-based ink than plain water. Dip the nib of your pen in a little bit of acetone-based nail polish remover and see if that does the trick.
Try to dip only the very tip of the pen in the acetone, since acetone can damage many types of plastic. Method 3. Scrape the nib on a rubber surface to get the ball rolling. Scribble on a rubber eraser or even the sole of your shoe. Shake the pen to move the ink down in the cartridge. Hold the end of your pen opposite the nib and give the pen several firm shakes, as if you were shaking down an old-fashioned glass thermometer.
Push the ink down in a wide cartridge with a cotton swab. If your pen has a wide enough cartridge, you may be able to push the ink down toward the nib. Unscrew the barrel of your pen and take out the cartridge, then pull the cap off the end of the cartridge. Push a cotton swab into the cartridge and apply gentle pressure to the fluid inside. Put your pen back together and test it again. First of all, try checking the cartridge to see if it looks like there's still ink inside.
If not, your pen might need a refill. You can purchase new cartridges online or from an office supply store. Otherwise, try running hot water over the nib to get the ink flowing and dissolve clogs, or shake your pen to get any bubbles out. But sometimes you fell in love with the beauty of your pen. In this case, your best option is to install a new refill.
This surely eliminates the problem without losing your pen. The following techniques, however, require some household materials to do the whole process. Write on your shoe. Scribbling hard is the first option. The process, however, needs a paper. In this very unlikely case, you can use the sole of your shoe as the surface to write on. A rubber shoe is a good one. The rubberized surface helps trap down the dried ink.
In an emergency situation, this could be your best option. Write on a rubber surface. This technique is similar to the first one. The only difference is that the latter needs a rubberized surface. There is no specific type of rubber recommended as long as it helps restore your pen. Use a ziplock bag. Removing a dried ink from the nib is not an easy task. One of the techniques you can use to dislodge it from the tip of the pen is by using a ziplock bag and hot water.
Put the ball pen inside the bag and seal it. Unfortunately, since most ballpoint pen cartridges have either a metal body or an opaque, plastic one, the ink level will not be visible.
If you are unsure about the amount of ink in your pen, then attempt the following suggestions. First, there might be an air bubble in the cartridge. If this is the case, you will see that there is a gap in the ink when you remove the cartridge from the pen barrel. The solution - Strike or poke the tip of the cartridge on a hard surface, but make sure to keep an eye on the bubble. As soon as the bubble disappears, stop striking and put the cartridge back into the pen.
Also, be aware that if you strike too much or too hard, there may be some ink spillage. Another reason why a ballpoint pen may not write is because it is being stored with the tip upright. Essentially, it uses a ball and socket, where gravity acts as the force pushing ink from the reservoir onto the ball.
Therefore, when a ballpoint pen is being stored tip up, gravity may push the ink in the opposite direction. The simple solution to this is simply to store the pen with the tip down and wait until gravity does its magic!
In contrast, a fountain pen should usually be stored with the nib upright, especially if carried in a bag or pen case. One of the more difficult ballpoint pen issues is when the ink clogs the tip. Unlike rollerball pens, ballpoint pens use thicker, oil-based ink. The rolling ball mechanism acts as a cap to stop the ink from drying out, but when left out, unused for long periods of time, it can clog up and stop the ink flow.
The first method to resolve a clogged ballpoint pen is to apply more pressure and draw scribbles and vertical lines on a piece of paper. If this method does not work, then dip the very tip of the pen in rubbing alcohol.
0コメント